September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Lumbar Assembly - Manual: Installation
- 1.
Position the manual lumbar control and install new rivets.
- 2.
Engage the manual lumbar retaining clips and cable retainer.
- 3.
Roll the backrest cover down and attach the hook-and-loop strips.
- 4.
Route the wire harness through the hole in the backrest cover and engage the lower J-clips.
- Make sure the manual lumbar cable is routed out from the outboard side of the backrest cover before engaging the lower J-clips.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.
 Courtesy of FORD MOTOR COMPANY
|
- 6.
Install the seat backrest. For additional information, refer to Seat Backrest - Front .