Bezel Diagnostics

WARNING: This page is about a different car, the 2016 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.

Check

1.

WARNING: Before beginning any service procedure in this article, refer to Health and Safety Precautions in General Information. Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions .

NOTE: If equipped with satellite radio, this procedure can be used to obtain the SIRIUS 12-digit ESN. If there is a concern with one of the following components and bezel diagnostics and channel 0 cannot be accessed, obtain the ESN by referencing the label attached to the ACM.

Inoperative (blank or does not power on) FCDIM (if equipped)
Inoperative (blank or does not power on) FDIM (if equipped)
Inoperative FCIM
Inoperative steering wheel switch (if applicable)

Refer to appropriate Information and Entertainment Systems article to diagnose the inoperative component.

NOTE: If there is a concern with one of the following components and Bezel Diagnostics cannot be accessed, obtain the module part number by referencing the label attached to the module.

Inoperative (blank or does not power on) FCDIM (if equipped)
Inoperative (blank or does not power on) FDIM (if equipped)
Inoperative FCIM
Inoperative steering wheel switch (if applicable)

Refer to appropriate Information and Entertainment Systems article to diagnose the inoperative component.

2.

Ignition ON.

3.

Operate the audio system in AM/ FM mode.

* For vehicles with a CD player, press and hold the EJECT button, and within 1 second, press and hold the SEEK UP button. If supported, the Speaker Walk-Around Test begins, and the display indicates each speaker as it is tested.
* For vehicles without a CD player, simultaneously press and hold the steering wheel SEEK UP switch and the FCIM TUNE UP button. If supported, the Speaker Walk-Around Test begins, and the display indicates each speaker as it is tested.

4.

Once the Speaker Walk-Around Test completes, the following information is available:

Applicability	Menu	Submenu
Only for vehicles with a FCDIM.	AHU Diagnostics (AHU refers to the ACM)	Software Part Number
		Hardware Part Number
		Calibration Part Number
		Radio Signal Strength (may need to press OK for signal strength to display)
		SIRIUS ESN
		Speaker Walk-Around Test
	EFP Diagnostics or EFP/ICP Diagnostics (EFP refers to the FCIM that communicates on the CAN; ICP refers to the FCIM that communicates on the LIN)	Software Part Number
Hardware Part Number
Calibration Part Number
Exit Diagnostics
MFD Diagnostics - if supported (MFD refers to the FCDIM)		Software Part Number
	Hardware Part Number
	Calibration Part Number
	Display Test (if supported)
Only for vehicles with FDIM touchscreen.	APIM Diagnostics	Part Numbers
		Software Versions
		Configuration Status
		GPS Information
		Tones Test
	Rear Tones Test (if equipped)
	Touch Screen Calibration
	Touch Screen Activation Test
	Display Test Pattern
	RGB Pixel Test
Exit Diagnostics
AHU Diagnostics (AHU refers to the ACM)	AHU Part Numbers / SIRIUS ESN or may also appear as SIRIUS ESN (also displays AHU part numbers)
	Radio Signal Strength
	Speaker Walk-Around Test (if not equipped with audio DSP module)
	Exit Diagnostics
DSP Diagnostics (if equipped)	DSP Part Numbers
	Speaker Walk-Around Test
	Exit Diagnostics
EFP Diagnostics - if equipped (EFP refers to the FCIM that communicates on the CAN)	EFP Part Numbers
	Exit Diagnostics

5.

To exit the bezel diagnostics, press the FCIM On/Off button or select "Exit Diagnostics."