Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
On certain 4x4 vehicles, the ATCM is used to activate and deactivate the selectable drive mode feature. When the driver presses the ATCM drive mode switch, the ATCM sends a drive mode message to the ABS module over the HS-CAN 2. The ABS module takes the necessary action depending on the selectable drive mode message.
PPT OB ABS MODULE DTC FAULT SETTING CONDITIONS
| DTC | Description | Fault Setting Conditions |
|---|---|---|
| P05D3:86 | Driver Mode Select Switch 'A' Range/Performance: Signal Invalid | This DTC sets if the selectable drive mode switch message sent from the TCM or PCM indicates the switch has been pressed for longer than 30 seconds. This can be caused by a short to ground on the selectable drive mode switch circuit, if there is an internal failure of the selectable drive mode switch or an internal failure of the TCM or PCM. |