Pinpoint Tests RJ: REDUCTANT Tank Level: Introduction

NOTE: Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.

This pinpoint test is intended to diagnose the following:

reductant quality module
reductant level sensor
harness circuits: CAN2+, CAN2-, GND, RDL1, RDL2, RDL3, SIGRTN and VPWR
reductant dosage control module (5H298)
PCM (12A650)

Fig 1: Reductant Heater And Sender Assembly Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
3	RDT (Reductant Temperature)
5	SIGRTN (Signal Return)
8	RDL3 (Reductant Level 3)
7	RDL2 (Reductant Level 2)
6	RDL1 (Reductant Level 1)

Fig 2: Reductant Quality Module Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
3	CAN2- (Controller Area Network 2)
2	CAN2+ (Controller Area Network 2)
1	GND (Ground)
4	VPWR (Vehicle Power)

Fig 3: Reductant Dosage Control Module Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
90	SIGRTN (Signal Return)
11	RDL3 (Reductant Level 3)
12	RDL2 (Reductant Level 2)
10	RDL1 (Reductant Level 1)

Fig 4: Powertrain Control Module-B (PCM-B) Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
39	CAN2- (Controller Area Network 2)
56	CAN2+ (Controller Area Network 2)

Fig 5: Powertrain Control Module-T (PCM-T) Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
36	CAN2- (Controller Area Network 2)
35	CAN2+ (Controller Area Network 2)