Powertrain Control Module (Pcm): Installation
- Install the PCM and connect the PCM electrical connectors..
- Position the PCM and attach the wiring retainer, install the retainers.
- Install the retainers and the PCM cover.
Torque
: 27 lb.in (3 Nm)
- Install the LHF fender splash shield. Refer to: Fender Splash Shield .
-
NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation and Component Description . Use the General Equipment: Ford Diagnostic Equipment
-
- Reprogram the PATS. Carry out the Parameter Reset procedure. For vehicles without Intelligent Access (IA). Refer to: Passive Anti-Theft System (PATS) Parameter Reset .
- Reprogram the PATS. Carry out the Parameter Reset procedure. For vehicles with Intelligent Access (IA). Refer to: Passive Anti-Theft System (PATS) Parameter Reset .
- After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.