Possible Causes

NOTE: This test requires the use of at least 2 keys programmed to the vehicle, one admin key and one restricted key.

BG1: VERIFY THAT THE KEY IN USE IS NOT RESTRICTED

Place a passive key inside the vehicle and all other passive keys at least 1 meter (3 feet) away from the vehicle.
Ignition ON, engine OFF.
Monitor the message center.
Does the message center display MYKEY ACTIVE DRIVE SAFELY?

Yes	No
The current key is a restricted key and is operating correctly. REPEAT the test using a different key until the message center does not display MYKEY ACTIVE DRIVE SAFELY. Go to BG2.	Go to BG2.

BG2: VERIFY THE MYKEY® TRACTION CONTROL SETTING

Using the message center, verify the MyKey® traction control setting. Refer to the Owner's Literature for instructions on setting the MyKey® functions.
Is the MyKey® traction control setting configured to always on?

Yes	No
Go to BG3.	Go to BG4.

BG3: VERIFY TRACTION CONTROL FUNCTION CAN BE DISABLED USING THE ADMIN KEY

Using the message center, verify traction control can be enabled and disabled using the admin key. Refer to the Owner's Literature for instructions on enabling and disabling traction control.
Can traction control be enabled and disabled using the admin key?

Yes	No
The system is operating correctly at this time. The concern may have been caused by the use of a restricted key. INFORM the customer the traction control can only be disabled using an admin key when the MyKey® traction control setting is configured to always on.	Go to BG4.

BG4: CHECK FOR ABS MODULE DTCS

Carry out the ABS self-test.

Yes	No
REFER to the ABS Module DTC Chart.	Go to BG5.

BG5: CHECK FOR GWM DTCS

Carry out the GWM self-test.

Yes	No
DIAGNOSE the GWM DTC. REFER to Module Communications Network article.	Go to BG6.

BG6: CHECK FOR FCIM DTCS

Carry out the FCIM self-test.

Yes	No
DIAGNOSE the FCIM DTC. REFER to Diagnosis and Testing in the appropriate Information and Entertainment System article.	The system is operating correctly at this time. The concern may have been caused due to high network traffic or an intermittent fault condition.