Powertrain Control Module (Pcm): Installation
- To install, reverse the removal procedure.
-
NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Use the General Equipment: Ford Diagnostic Equipment
-
- Reprogram the PATS. Carry out the Parameter Reset procedure. For vehicles without Intelligent Access (IA).
- Refer to: Passive Anti-Theft System (PATS) Parameter Reset .
- Refer to: Passive Anti-Theft System (PATS) Parameter Reset .
- After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.