LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2019 >> Escape Titanium, AWD >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> DTC Index (Exterior Lighting System - MULTIFUNCTION Electronic Modules) >> Information System And Entertainment System DTCS >> Am/Fm/Cd/Sync/Touchscreen Display >> FCIM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Am/Fm/Cd/Sync/Touchscreen Display: FCIM

DTC Description Action
B13DC:11 Compact Disc Slot Illumination: Circuit Short To Ground REFER to: Instrument Panel and Interior Switches Illumination .
B13DC:12 Compact Disc Slot Illumination: Circuit Short To Battery REFER to: Instrument Panel and Interior Switches Illumination .
B13DC:13 Compact Disc Slot Illumination: Circuit Open REFER to: Instrument Panel and Interior Switches Illumination .
U0155:87 Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message GO to Pinpoint Test AJ
U0257:87 Lost Communication With Front Controls / Display Interface Module: Missing Message GO to Pinpoint Test AP
U0423:00 Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. REFER to: Instrumentation, Message Center and Warning Chimes .
If no Diagnostic Trouble Codes (DTCs) are present in the IPC, DIAGNOSE the observable symptom.
U2013:63 Switch Pack: Circuit/Component Protection Time-Out CLEAR the Diagnostic Trouble Codes (DTCs).
WAIT at least 10 seconds.
REPEAT the self-test.
If DTC U2013:63 is retrieved again, Refer to FCIM GUIDED ROUTINE .
U201A:51 Control Module Main Calibration Data: Not Programmed This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the FCIM.
If there have been recent service actions with this module, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Configuration - System Operation and Component Description .
If there have been no recent service actions, Refer to FCIM GUIDED ROUTINE .
U3000:41 Control Module: General Checksum Failure CLEAR the DTC. WAIT 10 seconds and then REPEAT the FCIMself-test. If the DTC is retrieved again, INSTALL a new FCIM.
U3000:42 Control Module: General Memory Failure CLEAR the DTC. WAIT 10 seconds and then REPEAT the FCIM self-test. If the DTC is retrieved again, INSTALL a new FCIM.
U3003:16 Battery Voltage: Circuit Voltage Below Threshold GO to Pinpoint Test AQ
U3003:17 Battery Voltage: Circuit Voltage Above Threshold GO to Pinpoint Test AR
scientia non olet · About LEMON Manuals