Push Button Ignition Switch
The push button ignition switch is used to control the ignition mode.
There are 2 circuits the BCM monitors from the ignition switch to change the ignition mode. One circuit is monitored for voltage and the other for a ground signal. When the START/STOP button is pressed, one circuit routes battery voltage to the BCM while a voltage signal from the BCM on the second circuit is routed to ground, indicating a request to change the ignition mode. Changing the ignition mode out of OFF works in conjunction with the PATS. The BCM must recognize a valid programmed key before it changes the ignition mode out of OFF. Refer to: Passive Anti-Theft System (PATS) - System Operation and Component Description .
Refer to the following table for information about achieving the various ignition modes.
| Ignition Entry Condition | Desired Ignition Mode | Action To Take |
|---|---|---|
| Off | ON (engine off) | Press the START/STOP button without applying the brake pedal. |
| Off or on | START | Apply the brake pedal and then press the START/STOP button. |
| On (engine off) | OFF | Press the START/STOP button. |
| On (engine running) | OFF | Press and hold the START/STOP button. |