Passive Anti-Theft System - Perimeter
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B109F:01 | Intrusion Sensor Module: General Electrical Failure | GO to Pinpoint Test B |
| B109F:02 | Intrusion Sensor Module: General Signal Failure | GO to Pinpoint Test B |
| B109F:08 | Intrusion Sensor Module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B109F:49 | Intrusion Sensor Module: Internal Electronic Failure | INSTALL a new intrusion sensor. Refer to: Intrusion Sensor . |
| B109F:55 | Intrusion Sensor Module: Not Configured | Using a diagnostic scan tool, PERFORM the LIN New Module Initialization procedure (Toolbox> BCM> LIN New Module Initialization). |
| B109F:97 | Intrusion Sensor Module: Component or System Operation Obstructed or Blocked | GO to Pinpoint Test B |
| B109F:9A | Intrusion Sensor Module: Component or System Operating Conditions | GO to Pinpoint Test B |
| B11D9:09 | Vehicle Battery: Component Failure | GO to Pinpoint Test B |
| B1305:01 | Hood Switch: General Electrical Failure | GO to Pinpoint Test D |
| All other Diagnostic Trouble Codes (DTCs) | - | Refer to: Body Control Module (BCM) . |