Pinpoint Test F : The Remote Start Is Inoperative: Notes

WARNING: This page is about a different car, the 2018 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostic Overview

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods for information about these practices.

Normal Operation and Fault Conditions

The factory equipped remote start system enables the engine to be started from up to 100 meters (328 feet) away by pressing a sequence of buttons on the IKT or IA key. To activate the remote start system, press the lock button once to make sure the doors are locked, followed by 2 presses of the remote start button. The 3 button presses must occur within 3 seconds of each other. The IKT or IA key signal is received through an external antenna attached to the Tire Pressure Monitor Module (TPM) and communicated over the Medium Speed Controller Area Network (MS-CAN) to initiate the vehicle start.

Possible Sources

Wiring, terminals or connectors
Remote start feature enabled
IKT (vehicles without IA)
IA key (vehicles with IA)
External antenna
Hood switch input
PCM