Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the RCM sends messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within a certain time frame, the ABS module sets a DTCs. For information on the messages sent to the ABS module by the RCM, refer to the Description and Operation in the Anti-Lock Brake System (ABS) and Stability Control article.
PPT BH ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | This DTC sets if any one of the following messages is missing; yaw rate, lateral acceleration, longitudinal acceleration or roll rate. |
| U0452:83 | Invalid Data Received From Restraints Control Module: Value of Signal Protection Calculation Incorrect | This DTC sets if the yaw rate, roll rate, longitudinal acceleration or lateral acceleration calculated checksum is different than the actual checksum message from the RCM. |
| U0452:86 | Invalid Data Received From Restraints Control Module: Signal Invalid | This DTC sets if the information in any of the stability sensors messages (yaw rate, roll rate, lateral acceleration or longitudinal acceleration) contains invalid or out of range data. |