Steering Angle Sensor Module (SASM): Removal
WARNING: This page is about a different car, the 2020 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.
For information on Ford Color Coded Illustrations refer to OEM Color Coding
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the clockspring. Refer to: Clockspring .
- On both sides.
- Remove the screws.
- Push in the tabs and remove the steering column multifunction switch.
- Disconnect the SASM electrical connector and remove the 2 SASM upper screws.
Torque: 27 lb.in (3 Nm)
- Remove the 2 SASM lower screws, detach the wiring harness pin-type retainer and remove the SASM.
Torque: 27 lb.in (3 Nm)