LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2019 >> Fusion Titanium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 427 (MULTIFUNCTION Electronic Modules) >> Removal And Installation >> Body Control Module (BCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Body Control Module (BCM): Installation

WARNING: This page is about a different car, the 2020 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The BCM still communicates with the scan tool with the ignition off. Use the previous scan tool session or start a scan tool session using the part number or tear tag number on the PCM. The tear tag number can be found by double-clicking the VIN in the top left corner of PTS after OASIS has been run for the VIN.
NOTE: Low vehicle battery state-of-charge can affect proper module programming. Battery state-of-charge can be monitored on the scan tool. A red battery icon indicates low vehicle battery state-of-charge. Over-voltage may also affect module programming.

Make sure the battery is fully charged before  starting the installation procedure. Do not  have a battery charger connected to the vehicle charging system during the installation procedure.

  1. To install, reverse the removal procedure.
    NOTE: Carry out the remaining steps only if installing a new BCM.
  2. NOTE: You will not be able to confirm that transport mode has been deactivated until module programming has been completed.

    Deactivate transport mode in the BCM. Refer to: Transport and Factory Mode Deactivation .

  3. Using the previous scan tool session, complete the PMI process for the BCM following the on-screen instructions.
  4. Confirm that transport mode has been deactivated by verifying that transport mode is not displayed in the instrument cluster.
  5. Disable Factory Mode. Refer to: Transport and Factory Mode Deactivation .
  6. Using a diagnostic scan tool, enter the PATS functions and follow the on-screen instructions to enter PATS security access.

    • Select parameter reset BCM and PCM. Follow the on-screen instructions.

  7. Train the tire pressure sensors. Refer to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration .
  8. Carry out the BCM self-test, clear the Diagnostic Trouble Codes (DTCs) and then repeat the self-test to confirm all DTC have been cleared.
scientia non olet · About LEMON Manuals