| B117C:07 |
Rear Power Window Up: Mechanical Failure |
INITIALIZE the RH rear door window regulator motor. REFER to: Power Door Window Initialization
. |
| B117C:16 |
Rear Power Window Up: Circuit Voltage Below Threshold |
GO to Pinpoint Test G |
| B117C:4B |
Rear Power Window Up: Over Temperature |
WAIT 10 minutes to allow the window motor to cool. INITIALIZE the RH rear door window regulator motor. REFER to: Power Door Window Initialization
.
VERIFY the DTC is no longer present. If the DTC returns, INSPECT the window seals, glass runs and window regulator for a binding condition. REPAIR as necessary. |
| B117C:92 |
Rear Power Window Up: Performance or Incorrect Operation |
INITIALIZE the RH rear door window regulator motor. REFER to: Power Door Window Initialization
. |
| B117E:07 |
Front Power Window Up: Mechanical Failure |
INITIALIZE the passenger door window regulator motor. REFER to: Power Door Window Initialization
. |
| B117E:16 |
Front Power Window Up: Circuit Voltage Below Threshold |
GO to Pinpoint Test D |
| B117E:4B |
Front Power Window Up: Over Temperature |
WAIT 10 minutes to allow the window motor to cool. INITIALIZE the passenger door window regulator motor. REFER to: Power Door Window Initialization
.
VERIFY the DTC is no longer present. If the DTC returns, INSPECT the window seals, glass runs and window regulator for a binding condition. REPAIR as necessary. |
| B117E:92 |
Front Power Window Up: Performance or Incorrect Operation |
INITIALIZE the passenger door window regulator motor. REFER to: Power Door Window Initialization
. |
| B1189:11 |
Front Window Position Sensor: Circuit Short To Ground |
GO to Pinpoint Test D |
| B1189:16 |
Front Window Position Sensor: Voltage Below Threshold |
GO to Pinpoint Test D |
| B1189:17 |
Front Window Position Sensor: Voltage Above Threshold |
GO to Pinpoint Test D |
| B1189:29 |
Front Window Position Sensor: Signal Invalid |
GO to Pinpoint Test D |
| B1189:2B |
Front Window Position Sensor: Signal Cross Coupled |
GO to Pinpoint Test D |
| B1189:39 |
Front Window Position Sensor: Signal Has Too Few Pulses |
GO to Pinpoint Test D |
| B1189:3A |
Front Window Position Sensor: Signal Has Too Many Pulses |
GO to Pinpoint Test D |
| B1189:65 |
Front Window Position Sensor: Has Too Few Transitions / Events |
GO to Pinpoint Test D |
| B1189:77 |
Front Window Position Sensor: Commanded Position Not Reachable |
DIAGNOSE all other Diagnostic Trouble Codes (DTCs) first. If no other Diagnostic Trouble codes (DTCs) are present, INITIALIZE the RH front door window regulator motor. REFER to: Power Door Window Initialization
.
VERIFY the DTC is no longer present. If the DTC returns, INSPECT the window seals, glass runs and window regulator for a binding condition. REPAIR as necessary. |
| B118A:11 |
Rear Window Position Sensor: Circuit Short To Ground |
GO to Pinpoint Test G |
| B118A:16 |
Rear Window Position Sensor: Voltage Below Threshold |
GO to Pinpoint Test G |
| B118A:17 |
Rear Window Position Sensor: Voltage Above Threshold |
GO to Pinpoint Test G |
| B118A:29 |
Rear Window Position Sensor: Signal Invalid |
GO to Pinpoint Test G |
| B118A:2B |
Rear Window Position Sensor: Signal Cross Coupled |
GO to Pinpoint Test G |
| B118A:39 |
Rear Window Position Sensor: Signal Has Too Few Pulses |
GO to Pinpoint Test G |
| B118A:3A |
Rear Window Position Sensor: Signal Has Too Many Pulses |
GO to Pinpoint Test G |
| B118A:65 |
Rear Window Position Sensor: Has Too Few Transitions / Events |
GO to Pinpoint Test G |
| B118A:77 |
Rear Window Position Sensor: Commanded Position Not Reachable |
DIAGNOSE all other Diagnostic Trouble Codes (DTCs) first. If no other Diagnostic Trouble codes (DTCs) are present, INITIALIZE the RH rear door window regulator motor. REFER to: Power Door Window Initialization
.
VERIFY the DTC is no longer present. If the DTC returns, INSPECT the window seals, glass runs and window regulator for a binding condition. REPAIR as necessary. |
| B12C5:71 |
Front Window Lifter Motor Up Relay: Actuator Stuck |
GO to Pinpoint Test D |
| B12C6:71 |
Rear Window Lifter Motor Up Relay: Actuator Stuck |
GO to Pinpoint Test G |
| B12C7:71 |
Rear Window Lifter Motor Down Relay: Actuator Stuck |
GO to Pinpoint Test G |
| B12C8:71 |
Front Window Lifter Motor Down Relay: Actuator Stuck |
GO to Pinpoint Test D |
| B12E9:23 |
Rear Window Local Up/Down Switch: Signal Stuck Low |
GO to Pinpoint Test G |
| B12E9:24 |
Rear Window Local Up/Down Switch: Signal Stuck High |
GO to Pinpoint Test G |
| B13E5:23 |
Passenger Power Window Switch Up: Signal Stuck Low |
GO to Pinpoint Test D |
| B13E6:23 |
Passenger Power Window Switch Down: Signal Stuck Low |
GO to Pinpoint Test D |
| B13EF:4B |
Right Rear Power Window Motor: Over Temperature |
CLEAR the DTC. WAIT 10 minutes to allow the window motor to cool. INITIALIZE the RH rear door window regulator motor. REFER to: Power Door Window Initialization
.
VERIFY the DTC is no longer present. If the DTC returns, INSPECT the window seals, glass runs and window regulator for a binding condition. REPAIR as necessary. |
| B13F2:4B |
Passenger Power Window Motor: Over Temperature |
CLEAR the DTC. TEST the system for normal operation. If the DTC returns, INSTALL a new passenger door window regulator motor. REFER to: Front Door Window Regulator Motor
. |
| C1B14:11 |
Sensor Supply Voltage A: Circuit Short To Ground |
GO to Pinpoint Test D |
| C1B14:15 |
Sensor Supply Voltage A: Circuit Short To Battery or Open |
GO to Pinpoint Test D |
| C1B14:16 |
Sensor Supply Voltage A: Circuit Voltage Below Threshold |
GO to Pinpoint Test D |
| C1B14:17 |
Sensor Supply Voltage A: Circuit Voltage Above Threshold |
GO to Pinpoint Test D |
| C1B1A:11 |
Sensor Supply Voltage C: Circuit Short To Ground |
GO to Pinpoint Test G |
| C1B1A:15 |
Sensor Supply Voltage C: Circuit Short To Battery or Open |
GO to Pinpoint Test G |
| C1B1A:16 |
Sensor Supply Voltage C: Circuit Voltage Below Threshold |
GO to Pinpoint Test G |
| C1B1A:17 |
Sensor Supply Voltage C: Circuit Voltage Above Threshold |
GO to Pinpoint Test G |
| U2002:24 |
Switch: Signal Stuck High |
GO to Pinpoint Test D |
| All other Diagnostic Trouble Codes (DTCs) |
- |
REFER to: Locks, Latches and Entry Systems
. |