Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.
PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0300:51 | Internal Control Module Software Invompatibility: Not Programmed | Sets due to incomplete or improper module programming procedures. |
| U2017:57 | Control Module Software #2: Invalid/Incompatible Software Component | Sets due to incomplete or improper module programming procedures. |
| U2017:93 | Control Module Software #2: No Operation | Sets due to incomplete or improper module programming procedures. |
| U2024:51 | Control Module Cal-Config Data: Not Programmed | This DTC is only present when a new ABS module is installed, the ABS module is flashed or the ABS module is reconfigured. |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |