Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the CCM sends messages to the IPMA over a private CAN. The IPMA then sends the messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within the specified time frame, the module sets a DTC. This can be due to a CCM failure, an IPMA failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the CCM and IPMA, refer to the Network Message Chart in Description and Operation in the Anti-Lock Brake System (ABS) and Stability Control article.
PPT BW ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0433:82 | Invalid Data Received From Front Distance Range Sensor: Alive/Sequence Counter Incorrect/Not Updated | This DTC sets if the low speed collision mitigation rolling counter in the collision mitigation by braking deceleration message from the intrustion sensor is equal to 1 for longer than a predetermined amount of time. |