Information System And Entertainment System DTCS: DACMC
| DTC | Description | Action |
|---|---|---|
| B116A:01 | Handset Microphone: General Electrical Failure | GO to Pinpoint Test D |
| B117A:01 | Backup Microphone: General Electrical Failure | GO to Pinpoint Test D |
| B13F5:01 | Microphone 3: General Electrical Failure | GO to Pinpoint Test D |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test Z |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AB |
| U0142:00 | Lost Communication With Body Control Module "B": No Sub Type Information | |
| U2024:00 | Control Module Cal-Config Data: No Sub Type Information | This DTC sets due to an incorrect or incomplete DACMC configuration. Using a diagnostic scan tool, CARRY OUT the DACMC programming procedure using as-built data. REFER to: Module Programming . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incorrect or incomplete DACMC configuration. Using a diagnostic scan tool, CARRY OUT the DACMC programming procedure using as-built data. REFER to: Module Programming . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to an incorrect or incomplete DACMC configuration. Using a diagnostic scan tool, CARRY OUT the DACMC programming procedure using as-built data. REFER to: Module Programming . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds and then REPEAT the self-test. If the DTC is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds and then REPEAT the self-test. If the DTC is retrieved again, INSTALL a new ACM. REFER to: Audio Front Control Module (ACM) . |
| U3000:92 | Control Module: Performance or Incorrect Operation | GO to Pinpoint Test D |
| U3000:94 | Control Module: Unexpected Operation |
NOTE:
If an observable symptom is not
present, DISREGARD this DTC. GO to Pinpoint Test D |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AO |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AP |