Pinpoint Test E : Brake Shift Interlock System Does Not Release/Lock Correctly

Normal Operation and Fault Conditions
- Selector lever cable not secured to the bracket at the transmission
  - VERIFY the selector lever cable is fully seated in the cable bracket on the transmission. REFER to: Selector Lever Cable .
- Selector lever cable not secured to the bracket at the selector lever
  - VERIFY the selector lever cable is fully seated in the cable bracket at the front of the selector lever. REFER to: Selector Lever Cable .
- Circuit open, shorted to ground or shorted to power
  - GO to Pinpoint Test A
- Brake Shift Interlock Actuator (BSIA)
  - GO to Pinpoint Test A
Possible Sources
- Circuit open, shorted to ground or shorted to power
- Brake Shift Interlock Actuator (BSIA)
- Selector lever cable improperly installed or adjusted
Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods