| P06E4 |
Control Module Wake-up Circuit Performance |
RETRIEVE and RECORD all CM DTCs. If BCM DTC C113A:11 or C113A:15 is found, GO to Pinpoint Test C
Clear all Diagnostic Trouble Codes (DTCs). RERUN the PCM self-test. If the DTC returns, CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If no Technical Service Bulletins (TSBs) address this concern, Refer to PCM Guided Routine
. |
| P06E9 |
Engine Starter Performance |
If the engine cranks, Refer to Engine Controls - Symptom Charts (Except Diesel & Hybrid)
. If the engine does not crank, GO to Pinpoint Test A |
| P0830 |
Clutch Pedal Switch "A" Circuit |
GO to Pinpoint Test A |
| P1594 |
Forced Engine Shutdown - Remote Start System Fault, No Unattended Vehicle Timeout |
REFER to: Electronic Engine Controls
. |
| P1595 |
Forced Engine Shutdown - Remote Start System Fault, Transmission Range Not In Park Position |
REFER to: Electronic Engine Controls
. |
| P162F |
Starter Motor Disabled - Engine Crank Time Too Long |
Refer to Engine Controls - Symptom Charts (Except Diesel & Hybrid) |
| P2535 |
Ignition Switch Run/Start Position Circuit High |
GO to Pinpoint Test D |
| All Other DTCs |
-- |
Refer to Engine Controls - Symptom Charts (Except Diesel & Hybrid)
. |