Pinpoint Tests AF: Glow Plug System: Introduction
The wait-to-start indicator ON time is independent from the glow plug control module (GPCM)
NOTE:
Make sure the vehicle batteries are fully charged prior to carrying out the glow plug monitor self-test.
NOTE:
Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.
This pinpoint test is intended to diagnose the following:
- harness circuits: glow plug, CAN2+, CAN2-, ISP-R, PWRGND, VBATT, and VPWR
- glow plugs (12A342)
- GPCM (12B533)
Harness Side
| Circuit | Pin |
|---|---|
| VBATT (Battery Voltage) | 1 |
Harness Side
| Circuit | Pin |
|---|---|
| Glow Plug Number 1 | 1 |
| Glow Plug Number 2 | 2 |
| Glow Plug Number 3 | 5 |
| Glow Plug Number 4 | 6 |
| Glow Plug Number 5 | 7 |
| Glow Plug Number 6 | 8 |
| Glow Plug Number 7 | 11 |
| Glow Plug Number 8 | 12 |
Harness Side
| Circuit | Pin |
|---|---|
| VPWR (Vehicle Power) | 6 |
| PWRGND (Power Ground) | 5 |
| CAN2+ (Controller Area Network 2) | 3 |
| CAN2- (Controller Area Network 2) | 4 |
Harness Side
| Circuit | Pin |
|---|---|
| CAN2+ (Controller Area Network 2) | 56 |
| CAN2- (Controller Area Network 2) | 39 |
Harness Side
| Circuit | Pin |