| B116C:04 |
External SIM Cable/SIM Card: System Internal Failure |
CLEAR the DTC. WAIT 10 seconds and then REPEAT the TCU self-test. If the DTC is retrieved again, INSTALL a new TCU. |
| B1246:11 |
GSM (Group System for Mobile) Antenna: Circuit Short To Ground |
GO to Pinpoint Test U |
| B1246:13 |
GSM (Group System for Mobile) Antenna: Circuit Open |
GO to Pinpoint Test U |
| B1D55:11 |
Antenna #2: Circuit Short To Ground |
GO to Pinpoint Test V |
| B1D55:13 |
Antenna #2: Circuit Open |
GO to Pinpoint Test V |
| U0100:00 |
Lost Communication with ECM/PCM "A": No Sub Type Information |
GO to Pinpoint Test W |
| U0140:00 |
Lost Communication With Body Control Module: No Sub Type Information |
GO to Pinpoint Test Y |
| U0155:00 |
Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information |
GO to Pinpoint Test AA |
| U0253:00 |
Lost Communication With Accessory Protocol Interface Module: No Sub Type Information |
GO to Pinpoint Test AE |
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
This DTC sets due to an incorrect or incomplete TCU configuration. Using a diagnostic scan tool, CARRY OUT the TCUPMI procedure using as-built data. |
| U2101:00 |
Control Module Configuration Incompatible: No Sub Type Information |
This DTC sets due to an incorrect or incomplete TCU configuration. Using a diagnostic scan tool, CARRY OUT the TCUPMI procedure using as-built data. |
| U3000:04 |
Control Module: System Internal Failure |
CLEAR the DTC. WAIT 10 seconds and then REPEAT the TCU self-test. If the DTC is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module
. |
| U3000:41 |
Control Module: General Checksum Failure |
CLEAR the DTC. WAIT 10 seconds and then REPEAT the TCU self-test. If the DTC is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module
. |
| U3000:42 |
Control Module: General Memory Failure |
CLEAR the DTC. WAIT 10 seconds and then REPEAT the TCU self-test. If the DTC is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module
. |
| U3000:52 |
Control Module: Not Activated |
CLEAR the DTC. WAIT 10 seconds and then REPEAT the TCU self-test. If the DTC is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module
. |
| U3000:56 |
Control Module: Invalid / Incompatible Configuration |
CLEAR the DTC. WAIT 10 seconds and then REPEAT the TCU self-test. If the DTC is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module
. |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to Pinpoint Test AG |
| U3003:17 |
Battery Voltage: Circuit Voltage Above Threshold |
GO to Pinpoint Test AH |