DTC Chart: Body Control Module B (BCMB)
WARNING: This page is about a different car, the 2020 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
Body Control Module B (BCMB) DTC Chart
| DTC | Description | Action |
|---|---|---|
| B127B:11 | Ambient Lighting Zone 1 Output Red LED: Circuit Short To Ground | GO to Pinpoint Test I |
| B127B:15 | Ambient Lighting Zone 1 Output Red LED: Circuit Short To Battery or Open | GO to Pinpoint Test I |
| B127D:11 | Ambient Lighting Zone 3 Output Red LED: Circuit Short To Ground | GO to Pinpoint Test I |
| B127D:15 | Ambient Lighting Zone 3 Output Red LED: Circuit Short To Battery or Open | GO to Pinpoint Test I |
| B127E:11 | Ambient Lighting Zone 1 Output Green LED: Circuit Short To Ground | GO to Pinpoint Test I |
| B127E:15 | Ambient Lighting Zone 1 Output Green LED: Circuit Short To Battery or Open | GO to Pinpoint Test I |
| B1280:11 | Ambient Lighting Zone 3 Output Green LED: Circuit Short To Ground | GO to Pinpoint Test I |
| B1280:15 | Ambient Lighting Zone 3 Output Green LED: Circuit Short To Battery or Open | GO to Pinpoint Test I |
| B1281:11 | Ambient Lighting Zone 1 Output Blue LED: Circuit Short To Ground | GO to Pinpoint Test I |
| B1281:15 | Ambient Lighting Zone 1 Output Blue LED: Circuit Short To Battery or Open | GO to Pinpoint Test I |
| B1283:11 | Ambient Lighting Zone 3 Output Blue LED: Circuit Short To Ground | GO to Pinpoint Test I |
| B1283:15 | Ambient Lighting Zone 3 Output Blue LED: Circuit Short To Battery or Open | GO to Pinpoint Test I |
| U1000:00 | Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The Body Control Module B (BCMB) cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the Body Control Module B (BCMB) can withstand. The cause of the excessive current draw MUST be corrected before a new Body Control Module B (BCMB) is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, INSTALL a new Body Control Module B (BCMB). REFER to: Body Control Module B (BCMB) . |
| All other Body Control Module B (BCMB) Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module B (BCMB) . |