Wiper System And Washer System DTCS: SCCM
| DTC | Description | Action |
|---|---|---|
| B1008:09 | Wiper Mode Switch: Component Failure | If the windshield wipers are inoperative, INSTALL a new wiper/washer switch. REFER to: Steering Column Multifunction Switch RH
. CLEAR the DTC and repeat the self-test. If DTC B1008:09 is retrieved again, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM)
. If the windshield wipers are on continuously, GO to Pinpoint Test D |
| B1051:09 | Rear Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to: Steering Column Multifunction Switch RH
. CLEAR the DTC and repeat the self-test. If DTC B1051:09 is retrieved again, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) . |
| B1052:09 | Rear Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to: Steering Column Multifunction Switch RH
. CLEAR the DTC and repeat the self-test. If DTC B1052:09 is retrieved again, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) . |
| B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test F |
| B10AD:08 | Rain Sensor: Bus Signal / Message Failure | GO to Pinpoint Test F |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. REFER to: Rain Sensor . |
| B10AD:55 | Rain Sensor: Not Configured | CARRY OUT the Programmable Module Installation (PMI) for the SCCM using as built data. |
| B1131:01 | Wiper motor module: General Electrical Failure | GO to Pinpoint Test B |
| B1131:02 | Wiper motor module: General Signal Failure | GO to Pinpoint Test B |
| B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B1131:9A | Wiper motor module: Component or System Operating Conditions | DIAGNOSE the symptom present with the wiper/washer system. REFER to the Symptom Chart in this article. |
| B1131:11 | Wiper motor module: Circuit Short To Ground | GO to Pinpoint Test B |
| B1131:49 | Wiper motor module: Internal Electronic Failure | If only the passenger side wiper motor is inoperative, INSTALL a new passenger side windshield wiper motor. REFER to: Windshield Wiper Motor
. If both wiper motors are inoperative, INSTALL a new driver side windshield wiper motor. REFER to: Windshield Wiper Motor . |
| B1131:55 | Wiper motor module: Not Configured | CARRY OUT the Programmable Module Installation (PMI) for the SCCM using as built data. |
| B12F7:09 | Single Wipe Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to: Steering Column Multifunction Switch RH
. CLEAR the DTC and repeat the self-test. If DTC B12F7:09 is retrieved again, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) . |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Steering Wheel and Column Electrical Components . |