LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2020 >> Expedition XLT, 4WD >> Repair and Diagnosis >> General Information >> Specifications Index >> Common Specifications & Procedures >> Common Specifications & Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Common Specifications & Procedures

EXPEDITION COMMON SPECIFICATIONS & PROCEDURES

System Specification/Procedure
Air Conditioning
Service Specifications
Torque Refer to the specific component in Removal And Installation
Axle Nut/Hub Nut
Torque 30 lb.ft (40 Nm)
Battery
Specifications
Brakes
Bleeding Sequence Brake System Pressure Bleeding .
Disc Brakes
Front w/Torque Refer to the specific component in Removal And Installation
Rear w/Torque Refer to the specific component in Removal And Installation .
Charging
Generator w/Torque
Generator Stud Nut 35 lb.ft (47 Nm)
Generator Bolt 35 lb.ft (47 Nm)
Generator Stud 71 lb.in (8 Nm)
Drive Belts
Adjustment Accessory Drive Belt
Belt Routing Accessory Drive - Component Location
Engine Cooling
General Service Specifications Specifications
Radiator Cap Pressure 145 kPa (21 psi)
Thermostat R & I Thermostat
Water Pump R & I Coolant Pump .
Engine Mechanical
Compression Specifications .
Oil pressure @ 1, 500 rpm with engine at normal operating temperature (High mode) 30.0 psi (206.8 kPa)
Oil pressure @ 1, 500 rpm with engine at normal operating temperature (Low mode) 20.0 psi (138 kPa)
Overhaul Specifications
Torque Refer to the specific component in Removal And Installation
Fluid Specifications See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate Torque
For tightening sequence refer to Flexplate
59 Ft. Lbs. (80 Nm)
Fuel System
Fuel Filter Location The fuel tank(s) has a fuel filter that is part of the Fuel Pump (FP) module and cannot be serviced separately from the FP module
Fuel Filter R & I Fuel Pump And Sender Unit
Pressure Release Procedure Fuel System Pressure Release
Pressure Specification Specifications
Fuel Pressure Test Procedure Fuel System Pressure Check .
Ignition
Ignition Wires Engine has coil-on-plug ignition.
Firing Order & Cylinder Identification Firing Order & Cylinder Identification
Spark Plugs
Type CYF-S 12Y PCT
Gap 0.030 in (.75 mm)
Torque 15 Nm (133 lb-in)
Starting
Starter w/Torque 48 Nm (35 lb-ft)
Wheel Alignment
Adjustment Specifications Specifications
Torque General Procedures
Wheel & Tire
Wheel Lug Nut Torque 150 Ft. Lbs. (204 N.m)