LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2020 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> General Information >> DTC Index >> DTC Index (Engine Cooling System - Interior Lighting System) >> Exterior Lighting System DTCS >> STOPLAMPS >> BCMB
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Exterior Lighting System DTCS: STOPLAMPS: BCMB

DTC Description Action
B1271:11 Left Stop/Turn Inner Lamp: Circuit Short to Ground GO to Pinpoint Test B
B1271:15 Left Stop/Turn Inner Lamp: Circuit Short to Battery or Open GO to Pinpoint Test B
B1272:11 Right Stop/Turn Inner Lamp: Circuit Short To Ground GO to Pinpoint Test B
B1272:15 Right Stop/Turn Inner Lamp: Circuit Short To Battery or Open GO to Pinpoint Test B
B1273:11 Right Stop/Turn Middle Lamp: Circuit Short To Ground GO to Pinpoint Test B
B1273:15 Right Stop/Turn Middle Lamp: Circuit Short To Battery or Open GO to Pinpoint Test B
B1274:11 Left Stop/Turn Middle Lamp: Circuit Short To Ground GO to Pinpoint Test B
B1274:15 Left Stop/Turn Middle Lamp: Circuit Short To Battery or Open GO to Pinpoint Test B
B1275:11 Left Stop/Turn Outer Lamp: Circuit Short To Ground GO to Pinpoint Test B
B1275:15 Left Stop/Turn Outer Lamp: Circuit Short To Battery or Open GO to Pinpoint Test B
B1276:11 Right Stop/Turn Outer Lamp: Circuit Short To Ground GO to Pinpoint Test B
B1276:15 Right Stop/Turn Outer Lamp: Circuit Short To Battery or Open GO to Pinpoint Test B
U1000:00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCMB cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test.
U3000:49 Control Module: Internal Electronic Failure The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCMB can withstand. The cause of the excessive current draw MUST be corrected before a new BCMB is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, INSTALL a new BCMB. REFER to: Body Control Module B (BCMB) .
For other BCMB Diagnostic Trouble Codes (DTCs) - REFER to: Body Control Module B (BCMB) .