LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2020 >> Transit-250 Base, Van Cargo Extended, 3.5L Eng VIN 8, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Control System - General Information >> Diagnosis And Testing >> Climate Control System >> Pinpoint Tests >> Pinpoint Test T : Module Configuration Fault
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test T : Module Configuration Fault

  1. Normal Operation and Fault Conditions 

    Using a diagnostic scan tool, carry out the PMI procedure for the suspect module [ HVAC control module] as directed by the diagnostic scan tool. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new suspect module. REFER to the appropriate Removal and Installation procedure in this service information.

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    HVAC U2024:51 Control Module Cal-Config Data: Not Programmed This DTC sets due to incomplete or improper PMI procedures.
    HVAC U2100:00 Initial Configuration Not Complete: No Sub Type Information This DTC sets due to incomplete or improper PMI procedures.
    HVAC U2101:00 Control Module Configuration Incompatible: No Sub Type Information This DTC sets due to incomplete or improper PMI procedures.
    HVAC U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information This DTC sets due to incomplete or improper PMI procedures, or it may have an internal memory fault.

    Possible Sources 

    • Incomplete or incorrect PMI

  2. Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods

scientia non olet · About LEMON Manuals