LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2021 >> Bronco Base, 2D Utility, 2.3L Eng VIN H, Part Time T/Case Control, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 719 (Interior Camera System) >> Diagnosis And Testing >> Interior Camera System >> Pinpoint Tests >> Pinpoint Test N: U3000:98
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test N: U3000:98

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: The DTC may occur during extremely high ambient temperature. Allow the driver status monitor camera module to cool. The interior monitor system resumes operation after the module cools.

    Normal Operation and Fault Conditions 

    REFER to: Interior Camera System - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    CMR U3000:98 Control Module: Component Or System Over Temperature The DTC sets when the driver status monitor camera module detects the temperature above its calibrated range. This may occur during extended use in extremely high weather temperatures. The interior monitor system operation resumes after the driver status monitor camera module cools.

    Possible Sources 

    • Driver status monitor camera module (CMR) over temperature condition

  2. N1 CONFIRM THE DTC (DIAGNOSTIC TROUBLE CODE) RESETS

    • Ignition ON.

    • Connect the diagnostic tool.

    • Using the diagnostic scan tool, clear the DTC.

    • Wait 10 seconds.

    • Using the diagnostic scan tool, perform the CMR self-test.

    Is DTC U3000:98 still present? 

    Yes  GO to  N2
    No  The system is operating correctly at this time. The DTC may have been set due to an intermittent fault condition or the driver status monitor camera module may have cooled enough allowing the DTC to clear.

  3. N2 CHECK FOR CORRECT DRIVER STATUS MONITOR CAMERA MODULE OPERATION

    • Ignition OFF.

    • Disconnect and inspect the driver status monitor camera module connectors.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the driver status monitor camera module connectors. Make sure they seat and latch correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new driver status monitor camera module. REFER to: Driver Status Monitor Camera Module [CMR] .
    No  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals