Pinpoint Test J: U0415:86
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to MODULE COMMUNICATIONS NETWORK
for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Interior Camera System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition CMR U0415:86 Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": Signal Invalid A continuous memory DTC that sets in the driver status monitor camera module if messages from the ABS module over the FD-CAN are invalid. Possible Sources
- Communication network concern
- ABS module
- J1 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Connect the diagnostic tool.
- Using the diagnostic scan tool, perform a network test.
Does the ABS module pass the network test?
Yes GO to J2 No - J2 CHECK THE DRIVER STATUS MONITOR CAMERA MODULE CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODES (CMDTCS)
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).
- Wait 10 seconds.
- Using the diagnostic scan tool, check the CMR CMDTCs.
Is DTC U0415:86 retrieved again?
Yes DIAGNOSE any ABS module Diagnostic Trouble Codes (DTCs). REFER to: Anti-Lock Brake System (ABS) and Stability Control . No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.