| B130F:12 |
Run Accessory Control: Circuit Short To Battery |
GO to Pinpoint Test A |
| B130F:14 |
Run Accessory Control: Circuit Short To Ground or Open |
GO to Pinpoint Test A |
| B130F:14 |
Run Accessory Control: Circuit Short To Ground or Open |
GO to Pinpoint Test D |
| B1131:01 |
Wiper motor module: General Electrical Failure |
GO to Pinpoint Test A |
| B1131:02 |
Wiper motor module: General Signal Failure |
GO to Pinpoint Test A |
| B1131:02 |
Wiper Motor Module: General Signal Failure |
GO to Pinpoint Test D |
| B1131:08 |
Wiper motor module: Bus Signal / Message Failure |
GO to Pinpoint Test B |
| B1131:49 |
Wiper Motor Module: Internal Electronic Failure |
GO to Pinpoint Test P |
| B1131:55 |
Wiper Motor Module: Not Configured |
GO to Pinpoint Test O |
| B1131:9A |
Wiper Motor Module: Component or System Operating Conditions |
DIAGNOSE the symptom present with the wiper/washer system. REFER to the Symptom Chart
. |
| B124E:11 |
Wiper Stalk Switch Pack: Circuit Short To Ground |
GO to Pinpoint Test Q |
| B124E:13 |
Wiper Stalk Switch Pack: Circuit Open |
GO to Pinpoint Test Q |
| B124E:55 |
Wiper Stalk Switch: Not Configured |
GO to Pinpoint Test Q |
| B124E:96 |
Wiper Stalk Switch Pack: Component Internal Failure |
GO to Pinpoint Test Q |
| B124E:9E |
Wiper Stalk Switch Pack: Stuck On |
GO to Pinpoint Test Q |