Pinpoint Test V : A Door Passive Entry Feature Is Inoperative: Notes
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
A Door Passive Entry Feature Is Inoperative
Refer to Remote Keyless Entry and Alarm for schematic and connector information.
Normal Operations and Fault Conditions
REFER to: Handles, Locks, Latches and Entry Systems - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B1336:01 | Left Front Door External Antenna: General Electrical Failure | Sets when the BCM detects a fault from one of the circuits to the driver side keyless entry antenna (internal to the front driver exterior door handle). |
| B1337:01 | Right Front Door External Antenna: General Electrical Failure | Sets when the BCM detects a fault from one of the circuits to the passenger side keyless entry antenna (internal to the front passenger exterior door handle). |
| B1381:11 | Left Front Door Handle Proximity Sensor: Circuit Short To Ground | Sets when the BCM detects a fault from one of the circuits to the left front exterior door handle. |
| B1381:15 | Left Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | Sets when the BCM detects a fault from one of the circuits to the left front exterior door handle. |
| B1381:29 | Left Front Door Handle Proximity Sensor: Signal Invalid | Set when the BCM detects an activated touch sensor for more than 5 minutes. |
| B1382:11 | Right Front Door Handle Proximity Sensor: Circuit Short To Ground | Sets when the BCM detects a fault from one of the circuits to the right exterior door handle. |
| B1382:15 | Right Front Door Handle Proximity Sensor: Circuit Short To Battery or Open | Sets when the BCM detects a fault from one of the circuits to the right exterior door handle. |
| B1382:29 | Right Front Door Handle Proximity Sensor: Signal Invalid | Set when the BCM detects an activated touch sensor for more than 5 minutes. |
Possible Causes
- Wiring, terminals or connectors
- Door lock system concern
- RKE system concern
- Exterior door handle
- BCM
Visual Inspection and Diagnostic Pre-checks
- Inspect the exterior door handles for damage.