Pinpoint Test T: U1000:00
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
The BCM uses solid state drivers (Field Effect Transistors (FET)) to control the output of several vehicle systems. When an overload occurs on any of these drivers, the BCM disables the output and tracks the number of repetitive faults on each of these circuits. The module compares this number of overloads to three progressive thresholds established for each circuit. At each threshold, DTC U1000:00 sets along with the DTC associated with the affected circuit. REFER to: Module Controlled Functions - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition BCM U1000:00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information A continuous memory DTC that sets when the BCM has disabled a circuit due to a repetitive circuit overload and a progressive threshold is met. Possible Sources
- BCM output circuit short
- BCM
- T1 REVIEW THE BCM (BODY CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Connect the diagnostic tool.
- Using a diagnostic scan tool, perform the BCM self-test.
Are any BCM DTCs present besides U1000:00?
Yes CORRECT all other BCM DTCs first. REFER to the BCM DTC Chart. No GO to T2 - T2 REPEAT THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, clear the DTCs.
- Wait 10 seconds.
- Repeat the BCM self-test.
Is DTC U1000:00 still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new BCM. REFER to: Body Control Module (BCM) . No The system is operating correctly at this time.