Main Track Assembly

There is a RH and LH main track assembly that guides the movement of both the roof opening panel sliding glass and the roof opening panel shield. The RH and LH main track assemblies can be serviced separate from each other. The main track assemblies are serviced with the roof opening panel sliding glass cable and guide assembly, roof opening panel shield cable and guide assembly and the front cams all pre-assembled. Do not remove any of the cable and guide assemblies from the main track assemblies.  The front cams for the RH and LH main track assemblies, and the idler track assemblies are not interchangeable. The RH and LH roof opening panel sliding glass cable and guide assemblies on a new service component must be aligned before  the motors are installed during main track assembly service. Additionally, if only 1 main track assembly is being serviced, the other main track assembly must have the roof opening panel sliding glass cable and guide aligned following the applicable service information before installing the motors. The above cable and guide assembly alignment statements above also apply to the roof opening panel shield  cable and guides.