P2197 - O2 Sensor Signal Biased/Stuck Lean (Bank 2 Sensor 1)

DTC DESCRIPTION P2197 - O2 SENSOR SIGNAL BIASED/STUCK LEAN (BANK 2 SENSOR 1)

Description:	A universal heated oxygen sensor bank 2, sensor 1 (HO2S21) indicating lean at the end of a test is trying to correct for an over lean condition. This DTC sets when the fuel control system no longer detects switching for a calibrated amount of time.
Possible Causes:	Water in the harness connector UO2SPC21 circuit open Corrosion Incorrect connections Low fuel pressure or running out of fuel EVAP purge valve stuck open Biased MAP sensor signal Incorrect learned ethanol content Air leaks after the mass airflow (MAF) sensor (if equipped) Contaminated MAF sensor (if equipped) Vacuum leaks Positive crankcase ventilation (PCV) system is leaking Incorrectly seated engine oil level indicator Leaking gasket Camshaft timing Exhaust leaks before or near the universal HO2S21 Damaged universal HO2S21
Diagnostic Aids:
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to Pinpoint Test H.