Pinpoint Test P : The Automatic High Beam Feature Is Inoperative
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
In cold weather conditions (4 °C [40 °F] or less), the auto high beams are inhibited for 10 minutes to allow the camera windshield defrost heater to clear the windshield in front of the auto high beam camera.
- P1 VERIFY THE HIGH BEAM HEADLAMP OPERATION
- Place the headlamp switch in the HEADLAMPS ON position.
- Place the LH steering column multifunction switch in the HIGH BEAM position while observing the headlamps.
Do the high beam headlamps illuminate?
Yes GO to P2 No GO to Pinpoint Test E - P2 CHECK FOR IPMA (IMAGE PROCESSING MODULE A) DIAGNOSTIC TROUBLE CODE (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, perform the IPMA self-test.
Is DTC B11C7:97 present?
Yes GO to P4 No If no Diagnostic Trouble Code (DTCs) are present or only DTC B11C7:46 is present, GO to P3. If any other IPMA Diagnostic Trouble Code (DTCs) are present, REFER to: Lane Keeping System . - P3 CARRY OUT THE IPMA (IMAGE PROCESSING MODULE A) PMI (PROGRAMMABLE MODULE INSTALLATION) AND RETEST
- Carry out the IPMA PMI. Refer to: Module Programming .
- Clear the Diagnostic Trouble Codes (DTCs). Repeat the self-test.
Is the concern still present?
Yes INSTALL a new interior rear view mirror. Refer to: Interior Rear View Mirror . No The system is operating correctly at this time. The concern may have been caused by a temporary sensor obstruction. - P4 VERIFY THAT THE AUTOMATIC HIGH BEAM SENSOR IS NOT BLOCKED
- Visually verify the automatic high beam sensor is not blocked. Sources of blockage can include:
- stickers, window decals or tags.
- non-OEM window tinting.
Was the automatic high beam sensor blocked?
Yes If possible, REMOVE the blockage. TEST the system for normal operation. If the blockage cannot be removed, REVIEW the operation of the automatic high beams with the customer. No INSTALL a new interior rear view mirror. Refer to: Interior Rear View Mirror . - Visually verify the automatic high beam sensor is not blocked. Sources of blockage can include: