Pinpoint Test U: PSCM (Power Steering Control Module) DTC (Diagnostic Trouble Code) C1B00:62 Steering Angle Sensor
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE: Refer to Steering GSB for additional connector and wiring inspection tips.
Refer to Wiring Diagrams POWER STEERING CONTROLS for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Power Steering - Overview .
Description
- While the ignition is ON and the voltage supply to the PSCM is above 6 volts, the module monitors the motor inside the EPAS gear to calculate the relative and actual steering wheel angle. This value is transmitted to other modules over the HS-CAN.
Pinpoint Test Applicability
- This test applies to PSCM Diagnostic Trouble Codes (DTCs) C1B00:62 only.
IT DOES NOT apply to any other modules or Diagnostic Trouble Codes (DTCs).
DTC Diagnostic Strategy
- If the module DTC list results in a large number of Diagnostic Trouble Codes (DTCs), diagnose all module hard faults first (C102D, C1B00, C200B, C200C, C200D, U2011 and U3000) before diagnosing any network faults (lost communication or invalid data). If voltage concern Diagnostic Trouble Codes (DTCs) are present, diagnose those after any module hard faults and before any network faults. Diagnose all current and active Diagnostic Trouble Codes (DTCs) before diagnosing any historic Diagnostic Trouble Codes (DTCs).
Pinpoint Test Purpose
- Verify PSCMDTC C1B00:62 is present. Verify PSCM wiring harness and electrical connectors are in good condition.
Diagnostic Aids
- When DTC C1B00:62 is set, the PSCM removes steering assist, enters into manual mode and transmits an invalid steering angle message over the HS-CAN. The module also sends a message to the IPC to display
POWER STEERING ASSIST FAULT in the message center.
- If a damaged bellows boot(s) was discovered during inspection and this pinpoint test
DOES NOT lead to the installation of a new EPAS gear or bellows boot(s), ADDRESS the damaged boot(s) before returning the vehicle to the customer.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PSCM C1B00:62 Steering Angle Sensor: Signal Compare Failure This DTC sets if the sum of the 2 steering shaft torque sensors do not equal a specified voltage level. This can occur if the wiring harness is damaged, chewed or the connectors are loose or damaged. An internal steering gear or PSCM fault can also cause this DTC set. Possible Sources
- Steering gear internal failure
- PSCM internal failure
- NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector.
- COMPLETE THE FDRS GUIDED ROUTINE
- NOTE: This procedure must be completed using FDRS. Do not clear DTCs until the FDRS procedure has completed.To complete the diagnosis, navigate to the FDRS Guided Routine tab and carry out the procedure
Electronic Power Assist Steering (EPAS) Signal Error
- NOTE: This procedure must be completed using FDRS. Do not clear DTCs until the FDRS procedure has completed.To complete the diagnosis, navigate to the FDRS Guided Routine tab and carry out the procedure