Possible Causes
- SASM internal failure
- I1: RESET THE SASM AND RECHECK THE DTC
- Ignition ON.
- Using a diagnostic scan tool, clear all SASM Diagnostic Trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Using a diagnostic scan tool, carry out the SASM self-test.
Is any DTC from the DTC Fault Trigger Conditions Table present and active in teh SASM?
Yes No Go to I2. The condition causing the DTC is not preset at this time. CHECK all SASM electrical connectors for secure connections. - I2: RESET THE SASM AND RECHECK THE DTC
- Ignition ON.
- Using a diagnostic scan tool, carry out the SASM Reset Routine.
- Ignition OFF.
- Ignition ON.
- Using a diagnostic scan tool, carry out the SASM self-test.
Is the DTC present and active in the SASM?
Yes No INSTALL a new SASM - Clockspring assembly.
Refer to DRIVER AIRBAG - VEHICLES WITH: ADAPTIVE STEERING
Refer to CLOCKSPRING .The SASM reset has resolved the condition causing the DTC . The repair iscomplete.