Pinpoint Test G: Control Module Internal Faults
- Normal Operation and Fault Conditions
The TCCM and ATCM monitor the internal circuitry and memory for errors. If a fault is detected multiple times, a DTC is set.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition ATCM U2009:9E Rotary Encoder: Stuck On The ATCM has detected a short or open circuit for the rotary encoder optical sensor. The fault is internal to the ATCM. INSTALL a new ATCM. ATCM U2002:9E Switch: Stuck On The ATCM monitors the switch input every 10 ms. If the switch contacts are closed for more than 2 minutes, the ATCM will store a DTC. Mode selection will not be possible by pressing the button. Customer objects placed on the switch can cause this DTC to set. CLEAR the DTC and CARRY OUT the DTC On Demand self-test. If the DTC sets, INSTALL a new ATCM. ATCM U3000:49 Control Module: Internal Electronic Failure This DTC sets if voltage levels vary across different internal circuit. INSTALL a new ATCM. TCCM P06B8:00 Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error: No Sub Type Information Sets when the TCCM detects an internal control module Non-Volatile Random Access Memory (NVRAM) Error. INSTALL a new TCCM. TCCM U3000:04 Control Module: System Internal Failures This DTC sets if an internal error is detected while the clutch is on. INSTALL a new TCCM. TCCM U3000:46 Control Module: Calibration/Parameter Memory Failure This DTC sets if the two-point motor or clutch calibration is invalid. INSTALL a new TCCM. TCCM U3000:49 Control Module: Internal Electronic Failure This DTC sets if voltage levels vary across different internal circuit. INSTALL a new TCCM. Possible Sources
- TCCM
- ATCM
Diagnostic steps are not provided for this symptom or DTC. Refer to: Diagnostic Methods