| B10B8:63 |
Push Buttons: Circuit / Component Protection Time-Out |
This DTC sets when the buttons are held too long. ATTEMPT to clean buttons. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC does not return, IGNORE the DTC and CONTINUE diagnosing other Diagnostic Trouble Codes (DTCs) or symptoms. If the DTC returns, INSTALL a new RHVAC Control Module. Refer to REAR HEATING, VENTILATION AND AIR CONDITIONING (RHVAC) CONTROL MODULE |
| U0140:00 |
Lost Communication With Body Control Module: No Sub Type Information |
GO to Pinpoint Test W |
| U0164:00 |
Lost Communication With HVAC Control Module: No Sub Type Information |
GO to Pinpoint Test X |
| U0422:68 |
Invalid Data Received From Body Control Module: Event Information |
GO to Pinpoint Test W |
| U3000:41 |
Control Module: General Checksum Failure |
CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new RHVAC Control Module. Refer to REAR HEATING, VENTILATION AND AIR CONDITIONING (RHVAC) CONTROL MODULE |
| U3000:42 |
Control Module: General Memory Failure |
CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new RHVAC Control Module. Refer to REAR HEATING, VENTILATION AND AIR CONDITIONING (RHVAC) CONTROL MODULE |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to Pinpoint Test Y |
| U3003:17 |
Battery Voltage: Circuit Voltage Above Threshold |
GO to Pinpoint Test Z |