Possible Causes
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- A MyKey® restricted key is in use
- Network communication concern
- Message center concern
- IPC concern
- E1: VERIFY THE IGNITION KEY IN USE IS NOT RESTRICTED
- Ignition ON, engine OFF.
- Monitor the message center.
- Does the message center display MYKEY ACTIVE DRIVE SAFELY?
Yes No The current ignition key is a restricted key and is operating correctly. REPEAT the test step using a different ignition key until the message center does not display MYKEY ACTIVE DRIVE SAFELY.
Go to E2.Go to E2. - E2: VERIFY THE MYKEY® TRACTION CONTROL SETTING
- Using the message center, verify the MyKey traction control setting.
- Refer to the Owner's Literature for instructions on setting the MyKey functions.
- Is the MyKey traction control setting configured to always on?
Yes No Go to E3. Go to E4. - Using the message center, verify the MyKey traction control setting.
- E3: VERIFY TRACTION CONTROL FUNCTION CAN BE DISABLED USING THE ADMIN KEY
- Using the message center, verify traction control can be enabled and disabled using the admin ignition.
- Refer to the Owner's Literature for instructions on enabling and disabling traction control.
- Can traction control be enabled and disabled using the admin ignition key?
Yes No The system is operating correctly at this time. The concern may have been caused by the use of a restricted key. INFORM the customer the traction control can only be disabled using an admin key when the MyKey® traction control setting is configured to always on. Go to E4. - Using the message center, verify traction control can be enabled and disabled using the admin ignition.
- E4: CHECK FOR ABS MODULE DTCS
Carry out the ABS self-test.
- Are any DTCs present?
Yes No REFER to the ABS Module DTC Chart. Go to E5. - E5: CHECK FOR GWM DTCS
Carry out the GWM self-test.
- Are any DTCs present?
Yes No DIAGNOSE any GWM DTCs. REFER to the Module Communications Network article. Go to E7. - E6: CHECK FOR BCM DTCS
Carry out the BdyCM self-test.
- Are any DTCs present?
Yes No DIAGNOSE any BCM DTCs. REFER to the Multifunction Electronic Modules article. Go to E7. - E7: CHECK FOR IPC DTCS
Carry out the IPC self-test.
- Are any DTCs present?
Yes No DIAGNOSE any IPC DTCs. REFER to the Instrumentation, Message Center and Warning Chimes article. The system is operating correctly at this time. The concern may have been caused due to high network traffic or an intermittent fault condition.