Pinpoint Test AO: PSCM (Power Steering Control Module) DTC (Diagnostic Trouble Code) U0155:00
WARNING: This page is about a different car, the 2021 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Power Steering Controls for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Power Steering - System Operation and Component Description .
Description
- The PSCM monitors the HS-CAN messages when the ignition has been on for more than 5 seconds, the voltage to the PSCM is greater than 10 volts and there are no Diagnostic Trouble Codes (DTCs) present inhibiting PSCM operation.
Pinpoint Test Applicability
- This test applies to PSCM DTC U0155 Lost Communication with the IPC only. It does not apply to any other module except the PSCM.
DTC Diagnostic Strategy
- If the module DTC list results in a large number of Diagnostic Trouble Codes (DTCs), diagnose all module hard faults first (C102D, C1B00, C200B, C200C, C200D, U2011 and U3000) before diagnosing any network faults (lost communication or invalid data). If voltage concern Diagnostic Trouble Codes (DTCs) are present, diagnose those after any module hard faults and before any network faults. Diagnose all current and active Diagnostic Trouble Codes (DTCs) before diagnosing any historic Diagnostic Trouble Codes (DTCs).
Pinpoint Test Purpose
- To verify the PSCM wiring harness and connectors are OK. This test checks the connectors and wiring from the PSCM 3-pin connector at the steering column to the in-line connector in the passenger compartment. If these circuits are working correctly, the test then directs to check the IPC and wiring harness.
Diagnostic Aids
- For additional information on the messages sent to the PSCM from the IPC, refer to the Network Message List in Network Message Chart .
- Do not install a new PSCM as part of the repair for a PSCM DTC U0155:00.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| PSCM U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | This DTC sets if communications between the PSCM and the IPC fail. DTC U0155:00 can also be set due to a circuit fault in the HS-CAN, the PSCM wiring harness or a IPC concern. |
Possible Sources
- Fuse
- Wiring, terminals or connectors
- IPC
Visual Inspection and Pre-checks
- This DTC sets when the PSCM does not receive the IPC messages within a certain time frame. This can occur if the IPC wiring harness or electrical connectors are loose or damaged, or if the vehicle battery state of charge levels are low. Consult the DTC Index for additional information if needed.
- Refer to Steering GSB for additional connector and wiring inspection tips.
Pinpoint Tests AO: PSCM DTC U0155 Lost Communication With The IPC