Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| IPMA | B120C:11 | Heater for Windshield Mounted Sensor: Circuit Short To Ground | GO to Pinpoint Test C |
| IPMA | B120C:13 | Heater for Windshield Mounted Sensor: Circuit Open | GO to Pinpoint Test C |
| IPMA | B1385:68 | Lane Keeping Aid System: Event Information | GO to Pinpoint Test BG |
| IPMA | B1385:82 | Lane Keeping Aid System: Alive/Sequence Counter Incorrect/Not Updated | GO to Pinpoint Test BH |
| IPMA | B13A6:14 | Lane Departure Warning (LDW) Switch Input: Circuit Short To Ground Or Open | GO to Pinpoint Test A |
| IPMA | C0072:00 | Brake Temperature Too High: No Sub Type Information | GO to Pinpoint Test R |
| IPMA | C1001:31 | Vision System Camera: No Signal | GO to Pinpoint Test AZ |
| IPMA | C1001:49 | Vision System Camera: Internal Electronic Failure | GO to Pinpoint Test AW |
| IPMA | C1001:54 | Vision System Camera: Missing Calibration | GO to Pinpoint Test S |
| IPMA | C1001:78 | Vision System Camera: Alignment Or Adjustment Incorrect | GO to Pinpoint Test S |
| IPMA | C1001:95 | Vision System Camera: Incorrect Assembly | GO to Pinpoint Test AX |
| IPMA | C1001:97 | Vision System Camera: Component Or System Operation Obstructed Or Blocked | GO to Pinpoint Test T |
| IPMA | C1001:98 | Vision System Camera: Component Or System Over Temperature | GO to Pinpoint Test U |
| IPMA | U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test E |
| IPMA | U0101:00 | Lost Communication with TCM: No Sub Type Information | GO to Pinpoint Test F |
| IPMA | U0103:00 | Lost Communication With Gear Shift Control Module A: No Sub Type Information | GO to Pinpoint Test G |
| IPMA | U0104:00 | Lost Communication With Cruise Control Module: No Sub Type Information | GO to Pinpoint Test AJ |
| IPMA | U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information | GO to Pinpoint Test H |
| IPMA | U0122:00 | Lost Communication With Vehicle Dynamics Control Module: No Sub Type Information | GO to Pinpoint Test P |
| IPMA | U0130:00 | Lost Communication With Steering Effort Control Module: No Sub Type Information | GO to Pinpoint Test Q |
| IPMA | U0131:00 | Lost Communication With Power Steering Control Module "A": No Sub Type Information | GO to Pinpoint Test J |
| IPMA | U0138:00 | Lost Communication with All Terrain Control Module: No Sub Type Information | GO to Pinpoint Test AK |
| IPMA | U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test K |
| IPMA | U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | GO to Pinpoint Test L |
| IPMA | U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test M |
| IPMA | U0164:00 | Lost Communication With HVAC Control Module: No Sub Type Information | GO to Pinpoint Test AL |
| IPMA | U0199:00 | Lost Communication With "Door Control Module A": No Sub Type Information | GO to Pinpoint Test AM |
| IPMA | U0200:00 | Lost Communication With "Door Control Module B": No Sub Type Information | GO to Pinpoint Test AN |
| IPMA | U0212:00 | Lost Communication With Steering Column Control Module: No Sub Type Information | GO to Pinpoint Test N |
| IPMA | U0232:00 | Lost Communication With Side Obstacle Detection Control Module "A": No Sub Type Information | GO to Pinpoint Test I |
| IPMA | U0233:00 | Lost Communication With Side Obstacle Detection Control Module "B": No Sub Type Information | GO to Pinpoint Test I |
| IPMA | U0241:00 | Lost Communication With Headlamp Control Module "A": No Sub Type Information | GO to Pinpoint Test AO |
| IPMA | U024E:00 | Lost Communication With Side Obstacle Detection Control Module "C": No Sub Type Information | GO to Pinpoint Test I |
| IPMA | U024F:00 | Lost Communication With Side Obstacle Detection Control Module "D": No Sub Type Information | GO to Pinpoint Test I |
| IPMA | U0252:00 | Lost Communication With Lighting Control Module- Rear "B": No Sub Type Information | GO to Pinpoint Test BA |
| IPMA | U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test O |
| IPMA | U0264:00 | Lost Communication With Camera Module- Rear: No Sub Type Information | GO to Pinpoint Test BK |
| IPMA | U0293:00 | Lost Communication with Hybrid/EV Powertrain Control Module: No Sub Type Information | GO to Pinpoint Test E |
| IPMA | U0300:57 | Internal Control Module Software Incompatibility: Invalid/Incompatible Software Component | GO to Pinpoint Test AP |
| IPMA | U0401:82 | Invalid Data Received from ECM/PCM A: Alive/Sequence Counter Incorrect/Not Updated | GO to Pinpoint Test V |
| IPMA | U0401:83 | Invalid Data Received from ECM/PCM A: Value Of Signal Protection Calculation Incorrect | GO to Pinpoint Test V |
| IPMA | U0401:86 | Invalid Data Received from ECM/PCM A: Signal Invalid | GO to Pinpoint Test V |
| IPMA | U0402:86 | Invalid Data Received from TCM: Signal Invalid | GO to Pinpoint Test AQ |
| IPMA | U0404:86 | Invalid Data Received from Gear Shift Control Module A: Signal Invalid | GO to Pinpoint Test W |
| IPMA | U0405:86 | Invalid Data Received From Cruise Control Module: Signal Invalid | GO to Pinpoint Test BB |
| IPMA | U0415:82 | Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to Pinpoint Test H |
| IPMA | U0415:83 | Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": Value Of Signal Protection Calculation Incorrect | GO to Pinpoint Test H |
| IPMA | U0415:86 | Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": Signal Invalid | GO to Pinpoint Test H |
| IPMA | U0416:86 | Invalid Data Received From Vehicle Dynamics Control Module: Signal Invalid | GO to Pinpoint Test X |
| IPMA | U0419:86 | Invalid Data Received From Steering Effort Control Module: Signal Invalid | GO to Pinpoint Test Y |
| IPMA | U0420:86 | Invalid Data Received from Power Steering Control Module "A": Signal Invalid | GO to Pinpoint Test Z |
| IPMA | U0422:86 | Invalid Data Received From Body Control Module: Signal Invalid | GO to Pinpoint Test BC |
| IPMA | U0423:86 | Invalid Data Received from Instrument Panel Cluster Control Module: Signal Invalid | GO to Pinpoint Test AA |
| IPMA | U0424:86 | Invalid Data Received From HVAC Control Module: Signal Invalid | GO to Pinpoint Test BD |
| IPMA | U0429:86 | Invalid Data Received From Steering Column Control Module: Signal Invalid | GO to Pinpoint Test AB |
| IPMA | U0452:82 | Invalid Data Received From Restraints Control Module: Alive/Sequence Counter Incorrect/Not Updated | GO to Pinpoint Test AR |
| IPMA | U0452:83 | Invalid Data Received From Restraints Control Module: Value Of Signal Protection Calculation Incorrect | GO to Pinpoint Test AS |
| IPMA | U0452:86 | Invalid Data Received From Restraints Control Module: Signal Invalid | GO to Pinpoint Test AC |
| IPMA | U049A:86 | Invalid Data Received From "Door Control Module A": Signal Invalid | GO to Pinpoint Test AT |
| IPMA | U0501:86 | Invalid Data Received From "Door Control Module B": Signal Invalid | GO to Pinpoint Test AU |
| IPMA | U0533:86 | Invalid Data Received From Side Obstacle Detection Control Module "A": Signal Invalid | GO to Pinpoint Test I |
| IPMA | U0534:86 | Invalid Data Received From Side Obstacle Detection Control Module "B": Signal Invalid | GO to Pinpoint Test I |
| IPMA | U054F:86 | Invalid Data Received From Side Obstacle Detection Control Module "C": Signal Invalid | GO to Pinpoint Test I |
| IPMA | U0550:86 | Invalid Data Received From Side Obstacle Detection Control Module "D": Signal Invalid | GO to Pinpoint Test I |
| IPMA | U0554:86 | Invalid Data Received From Accessory Protocol Interface Module: Signal Invalid | GO to Pinpoint Test BE |
| IPMA | U0565:82 | Invalid Data Received From Camera Module-Rear: Alive/Sequence Counter Incorrect/Not Updated | GO to Pinpoint Test BL |
| IPMA | U0565:83 | Invalid Data Received From Camera Module-Rear: Value Of Signal Protection Calculation Incorrect | GO to Pinpoint Test BL |
| IPMA | U0565:86 | Invalid Data Received From Camera Module-Rear: Signal Invalid | GO to Pinpoint Test BL |
| IPMA | U0594:86 | Invalid Data Received From Hybrid/EV Powertrain Control Module: Signal Invalid | GO to Pinpoint Test BI |
| IPMA | U1000:11 | Solid State Driver Protection Active -Driver Disabled: Circuit Short To Ground | GO to Pinpoint Test AD |
| IPMA | U100B:64 | Semi-Automatic Parallel Parking System: Signal Plausibility Failure | GO to Pinpoint Test BM |
| IPMA | U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to Pinpoint Test AE |
| IPMA | U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | GO to Pinpoint Test BJ |
| IPMA | U2300:55 | Central Configuration: Not Configured | GO to Pinpoint Test AF |
| IPMA | U2300:64 | Central Configuration: Signal Plausibility Failure | GO to Pinpoint Test AG |
| IPMA | U3000:42 | Control Module: General Memory Failure | GO to Pinpoint Test AH |
| IPMA | U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test AI |
| IPMA | U3000:51 | Control Module: Not Programmed | GO to Pinpoint Test AV |
| IPMA | U3000:89 | Control Module: Data Transfer Failure | GO to Pinpoint Test BN |
| IPMA | U3000:98 | Control Module: Component Or System Over Temperature | GO to Pinpoint Test BF |
| IPMA | U3003:A2 | Battery Voltage: System Voltage Low | GO to Pinpoint Test AY |