Wiper System And Washer System DTCS
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B130F:12 | Run Accessory Control: Circuit Short To Battery | GO to Pinpoint Test A |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | If the windshield wipers are inoperative, GO to Pinpoint Test A If the windshield wipers operate with the ignition OFF, GO to Pinpoint Test D |
| B1051:12 | Front Washer Switch: Circuit Short To Battery | GO to Pinpoint Test I |
| B1052:12 | Rear Washer Switch: Circuit Short To Battery | GO to Pinpoint Test K |
| B13A4:11 | Front Wiper Fast Mode Input: Circuit Short To Ground | GO to Pinpoint Test D |
| B10AD:01 | Rain Sensor: General Electrical Failure | GO to Pinpoint Test F |
| B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test F |
| B10AD:08 | Rain Sensor: Bus Signal / Message Failure | GO to Pinpoint Test F |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | GO to Pinpoint Test F |
| B10AD:55 | Rain Sensor: Not Configured | GO to Pinpoint Test S |
| B10AD:9A | Rain Sensor: Component or System Operating Conditions | GO to Pinpoint Test U |
| B1131:01 | Wiper motor module: General Electrical Failure | GO to Pinpoint Test A |
| B1131:02 | Wiper Motor Module: General Signal Failure | If the wipers are inoperative, or no symptom is present, GO to Pinpoint Test A If the wipers are always on, GO to Pinpoint Test D |
| B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B1131:49 | Wiper Motor Module: Internal Electronic Failure | GO to Pinpoint Test R |
| B1131:55 | :Wiper Motor Module: Not Configured | GO to Pinpoint Test S |
| B1131:9A | Wiper motor module: Component or System Operating Conditions | GO to Pinpoint Test U |