Common Specifications & Procedures

TRANSIT COMMON SPECIFICATIONS & PROCEDURES

System			Specification/Procedure
Air Conditioning
Service			Specifications
Torque			Refer to appropriate component in Removal And Installation (1 of 2) and Removal And Installation (2 of 2)
Axle Nut/Hub Nut			Axle Nut Stage 1: 74 lb.ft (100 Nm) Stage 2: 184 lb.ft (250 Nm) Stage 3: 380 lb.ft (515 Nm) Hub Nut Vehicles with Drum In Hat Parking Brake Stage 1: 70 lb.ft (95 Nm) Stage 2: Loosen: 180° Stage 3: 25 lb.ft (34 Nm) Vehicles equipped with Drum in Hat Stage 1: 65 lb.ft (88 Nm) Stage 2: Loosen: 180° Stage 3: 25 lb.ft (34 Nm)
Battery			Specifications
Brakes
Bleeding Sequence			RR, LR, RF, LF Brake System Pressure Bleeding
Front Disc Brakes w/Torque			Refer to appropriate component in Removal And Installation
Rear Disc Brakes w/Torque			Refer to appropriate component in Removal And Installation
Charging
Generator w/Torque
	3.5L EcoBoost		Generator Mounting Nut: Torque: 35 lb.ft (47.5 Nm) Generator Mounting Bolt: Torque: 35 lb.ft (47.5 Nm) Generator Stud: 71 lb.in (8 Nm) Generator - Secondary, if equipped 35 lb.ft (47.5 Nm)
	3.5L Duratec		Generator Bolt and Nut: 35 lb.ft (47.5 Nm) Generator - Secondary, if equipped 35 lb.ft (47.5 Nm)
Drive Belts
Adjustment
	3.5L Duratec		Accessory Drive Belt
	3.5L EcoBoost		Accessory Drive Belt
Belt Routing
	3.5L Duratec		Accessory Drive - Component Location
	3.5L EcoBoost		Accessory Drive - Component Location
Engine Cooling
General Service Specifications
	3.5L Duratec		Specifications
	3.5L EcoBoost		Specifications
		Electrified Drivetrain	Motor Electronics Specifications High Voltage Battery Specifications
Radiator Cap Pressure
	3.5L Duratec		120 kPa (17.4 psi) to 150 kPa (21.7 psi)
	3.5L EcoBoost		120 kPa (17.4 psi) to 150 kPa (21.7 psi)
Thermostat R & I
	3.5L Duratec		Thermostat .
	3.5L EcoBoost		Thermostat .
Water Pump R & I
	3.5L Duratec		Coolant Pump
	3.5L EcoBoost		Coolant Pump
		Electrified Drivetrain	Motor Electronics Coolant Pump High Voltage Battery Coolant Pump
Engine Mechanical
Compression
	3.5L EcoBoost		Specifications
	3.5L Duratec		Specifications
	Oil Pressure
		3.5L EcoBoost	Oil pressure @ 1, 500 rpm with engine at normal operating temperature: 30.0 psi (206.8 kPa)
		3.5L Duratec	Oil pressure @ 1, 500 rpm with engine at normal operating temperature: 21.8 psi (150 kPa)
Overhaul
	3.5L EcoBoost		Specifications
	3.5L Duratec		Specifications
Torque
	3.5L EcoBoost		Refer to the appropriate component in Removal And Installation
	3.5L Duratec		Refer to the appropriate component in Removal And Installation
Fluid Specifications			See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate Torque
3.5L Ecoboost			Flexplate .
3.5L Duratec			Flexplate
Fuel System
Fuel Filter Location
	3.5L Ecoboost/3.5L Duratec		The system contains 3 to 5 filtering or screening devices. The fuel intake filter or screen is a fine nylon mesh filter mounted on the intake side of the fuel pump. It is part of the assembly and cannot be repaired separately. The filter/screen at the fuel rail port of the injectors is part of the fuel injector assembly and cannot be repaired separately The filter/screen at fuel inlet side of the fuel pressure regulator is part of the regulator assembly and cannot be repaired separately. The fuel filter assembly is located between the fuel pump and injectors. This filter may be a lifetime fuel filter located in the fuel pump assembly or an external 3 port inline filter that allows clean fuel to return to the fuel tank. A new filter may be installed for the external filter. The fuel filter sock is located on the fuel pump assembly between the reservoir and the fuel tank.
Fuel Filter R & I
		3.5L EcoBoost	Fuel Pump And Sender Unit
		3.5L Duratec	Fuel Pump And Sender Unit
Pressure Release Procedure
		3.5L EcoBoost	Fuel System Pressure Release
		3.5L Duratec	Fuel System Pressure Release
Fuel pressure
	3.5L EcoBoost		Engine running 71.1 psi (490 kPa)
	3.5L Duratec		Engine running 75.4 psi (520 kPa)
Fuel Pressure Test Procedure
		3.5L EcoBoost	Fuel System Pressure Check
		3.5L Duratec	Fuel System Pressure Check
Ignition
Firing Order & Cylinder Identification			Firing Order & Cylinder Identification
Ignition Wires (Routing)			Engine has coil-on-plug ignition.
Spark Plug
3.5L EcoBoost
	Type		CYFS 12 YT4X
Gap			0.028-0.037 in (.7-.95 mm)
Torque			133 lb.in (15 Nm)
	3.5L Duratec
	Type		CYFS 12F 5X
		Gap	0.051 in (1.3 mm)
		Torque	133 lb.in (15 Nm)
Starting
Starter
		3.5L EcoBoost	Specifications
		3.5L Duratec	Specifications
Torque
	3.5L EcoBoost		Starter Motor Mounting Bolts: 26 lb.ft (35 Nm)
		3.5L Duratec	Starter Motor Mounting Bolts: 26 lb.ft (35 Nm)
Wheel Alignment
Adjustment Specifications			Specifications
Torque			Refer to the appropriate procedure in General Procedures
Wheel & Tire
Wheel Lug Nut Torque			For tightening sequence, refer to Wheel And Tire or Wheel and Tire - Vehicles With: Dual Rear Wheels . 150 lb.ft (204 Nm)