DTC C1B00: Steering Angle Sensor: Description

While the ignition is ON and the voltage supply to the PSCM is between 11 and 16 volts, the module monitors the motor inside the EPAS column to calculate the relative and actual steering wheel angle. This value is transmitted to other modules over the HS-CAN.

• DTC C1B00:49 (Steering Angle Sensor: Internal Electronic Failure) - If the PSCM detects an invalid steering angle, the steering system has not been calibrated, the internal steering angle exceeds or falls below the calculated value, DTC C1B00:49 is set.
• DTC C1B00:62 (Steering Angle Sensor: Signal Compare Failure) - If the PSCM detects an invalid steering angle sensor when compared to index sensor and redundant steering angle signal or the steering angle is out of range, DTC C1B00:62 is set.