Interior Camera System DTCS
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B115E:49 | Camera Module: Internal Electronic Failure | GO to Pinpoint Test A |
| B115E:54 | Camera Module: Missing Calibration | GO to Pinpoint Test B |
| B115E:78 | Camera Module: Alignment Or Adjustment Incorrect | GO to Pinpoint Test B |
| B115E:97 | Camera Module: Component Or System Operation Obstructed Or Blocked | GO to Pinpoint Test D |
| B115E:98 | Camera Module: Component Or System Over Temperature | GO to Pinpoint Test E |
| B15E1:11 | Driver Side LED: Circuit Short To Ground | GO to Pinpoint Test C |
| B15E1:12 | Driver Side LED: Circuit Short To Battery | GO to Pinpoint Test C |
| B15E1:13 | Driver Side LED: Circuit Open | GO to Pinpoint Test C |
| B15E1:97 | Driver Side LED: Component Or System Operation Obstructed Or Blocked | GO to Pinpoint Test D |
| B15E2:11 | Passenger Side LED: Circuit Short To Ground | GO to Pinpoint Test C |
| B15E2:12 | Passenger Side LED: Circuit Short To Battery | GO to Pinpoint Test C |
| B15E2:13 | Passenger Side LED: Circuit Open | GO to Pinpoint Test C |
| B15E2:97 | Passenger Side LED: Component Or System Operation Obstructed Or Blocked | GO to Pinpoint Test D |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test F |
| U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information | GO to Pinpoint Test G |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test H |
| U0401:86 | Invalid Data Received from ECM/PCM A: Signal Invalid | GO to Pinpoint Test I |
| U0415:86 | Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": Signal Invalid | GO to Pinpoint Test J |
| U0422:86 | Invalid Data Received From Body Control Module: Signal Invalid | GO to Pinpoint Test K |
| U2018:51 | Control Module Software #3: Not Programmed | GO to Pinpoint Test L |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to Pinpoint Test L |
| U3000:41 | Control Module: General Checksum Failure | GO to Pinpoint Test M |
| U3000:42 | Control Module: General Memory Failure | GO to Pinpoint Test M |
| U3000:44 | Control Module: Data Memory Failure | GO to Pinpoint Test M |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test M |
| U3000:98 | Control Module: Component Or System Over Temperature | GO to Pinpoint Test N |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test O |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test P |