Wiper System And Washer System DTCS
Diagnostics in this information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B130F:12 | Run Accessory Control: Circuit Short To Battery | GO to Pinpoint Test A |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test A |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test D |
| B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test F |
| B10AD:08 | Rain Sensor: Bus Signal / Message Failure | GO to Pinpoint Test F |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | GO to Pinpoint Test Q |
| B10AD:55: | Rain Sensor: Not Configured | GO to Pinpoint Test P |
| B1131:02 | Wiper motor module: General Signal Failure | GO to Pinpoint Test A |
| B1131:02 | Wiper Motor Module: General Signal Failure | GO to Pinpoint Test D |
| B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B1131:49 | Wiper Motor Module: Internal Electronic Failure | GO to Pinpoint Test R |
| B1131:55: | Wiper Motor Module: Not Configured | GO to Pinpoint Test P |
| B124E:11 | Wiper Stalk Switch Pack: Circuit Short To Ground | GO to Pinpoint Test V |
| B124E:13 | Wiper Stalk Switch Pack: Circuit Open | GO to Pinpoint Test V |
| B124E:55 | Wiper Stalk Switch: Not Configured | GO to Pinpoint Test V |
| B124E:96 | Wiper Stalk Switch Pack: Component Internal Failure | GO to Pinpoint Test V |
| B124E:9E | Wiper Stalk Switch Pack: Stuck On | GO to Pinpoint Test V |