A/C Request (Non-hybrid)

When the A/C is requested, the HVAC control module sends the message over the MS-CAN to the GWM. The GWM sends the A/C request through the FD-CAN to the PCM.

When an A/C request is received by the PCM, the A/C clutch FET in the BCMC is enabled when all of the following conditions are met:

Excessively high or low refrigerant pressure from the A/C pressure transducer is not detected.
Ambient air temperature is above approximately 0deg. C (32deg. F).
Evaporator temperature is above approximately 0deg. C (32deg. F).
Engine coolant temperature conditions are within normal parameters.
Wide Open Throttle (WOT) condition is not present.
Engine torque conditions are within normal parameters.
Battery state of charge conditions are within normal parameters.

Compressor control and the evaporator temperature are a function of many parameters, not just a straight on/off, to avoid freezing the evaporator. The PCM monitors multiple temperature sensors for correlation including, but not limited to, AAT, CACT, CHT, ECT, IAT, IAT2, MAF, MAPT, TCB and TCIPT Parameter Identifications (PIDs) (as applicable). The PCM runs this logic after an engine off and a calibrated soak period of 6 to 8 hours. This soak period allows the Ambient Air Temperature (AAT) sensor and the other temperature sensors to stabilize and not differ by greater than a calibrated value, typically 18 deg. C (32.4 deg. F). If a temperature sensor input is found to be reporting a temperature imbalance the PCM does not allow the A/C clutch to engage.

The PCM monitors the discharge pressure measured by the A/C pressure transducer. The PCM interrupts A/C compressor operation in the event the A/C pressure transducer indicates high system discharge pressures. It is also used to sense low charge conditions. If the pressure is below a predetermined value for a given ambient temperature, the PCM does not allow the A/C clutch to engage.

The HVAC control module adjusts the air inlet door depending on the humidity measured by the in-vehicle temperature and humidity sensor. If the vehicle cabin becomes too humid and recirculated air is selected, the HVAC control module adjusts the air inlet door to allow more fresh air. When the humidity level drops, it adjusts back to partial recirculated air. The HVAC control module also adjusts the system based on in-vehicle temperature.