Pinpoint Test J: Abs Module Communication Concern With SASM
Normal Operation and Fault Conditions
With the ignition ON, the SASM sends messages to the GWM over the HS-CAN2. The GWM relays these messages to the ABS module over the FD-CAN. If the ABS module does not receive these messages within the allotted time frame or if the messages contain invalid data, the module sets a DTC. This can be due to a SASM failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the SASM, refer to Network Message Chart , Description and Operation in the Service Articles.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U0126:00 | Lost Communication With Steering Angle Sensor Module: No Sub Type Information | This DTC sets when the ABS module does not receive any messages from the SASM within the allowed time. |
Possible Sources
- Network communication concern
- SASM