Anti-Lock Brake System (ABS) Module

The ABS module is the ECU for the ABS and stability control systems. The module monitors all sensor inputs and all HS-CAN messages relating to ABS and stability control, then directly controls the solenoid valves and the hydraulic pump motor in the HCU.

The ABS module is attached directly to the HCU but is available separately for service.

When a new ABS module is installed, the module must be programmed with the current vehicle configuration information. For additional information on module programming, Refer to: Module Configuration - System Operation and Component Description .

When an ABS or stability control fault has been corrected or a new component has been installed, the ABS module must be calibrated. The calibration procedure is required for the stability control sensors to learn the zero-position of the vehicle which means the vehicle must be on a level surface and not moving. The ABS Calibration procedure is carried out using a diagnostic scan tool.